GET HOOKED ON OUR BADGE REELS! ENTER CODE: NEW10 FOR FIRST TIME ORDERS

Product Care

THE CRAFT HOUSE COLLECTIVE

A little care keeps the personality going.

Thank you for choosing handmade! Choose your product below for simple cleaning, handling, and storage tips.

Badge Reel Care

Keep it clean

  • Gently wipe the decorative topper with a soft, slightly damp cloth, then dry it.
  • Do not soak or submerge the reel in water.
  • Avoid alcohol, acetone, bleach, abrasive cleaners, and rough scrubbing on the decorative topper.

Use it gently

  • Pull the badge strap gently and straight out. Avoid yanking or pulling beyond the cord’s reach.
  • Guide your badge back instead of letting the cord snap back.
  • Keep the attached load light. Heavy keys and accessories can strain the reel.

Protect the details

  • Avoid drops, hard impacts, and bending the acrylic topper.
  • Keep your reel away from excessive heat, hot vehicles, and prolonged direct sunlight.
  • If your design includes a charm or a liquid-filled piece, handle those details gently. Do not open or puncture sealed pieces.

Store with care

Store your reel in a cool, dry place where the cord and any charms will not become tangled or crushed.

A note for healthcare settings

Follow your workplace’s infection-control and accessory policies. These tips care for the decorative item; they are not disinfection instructions. If your workplace requires a cleaning method that may damage the decoration, use a workplace-approved badge holder instead.

3D Printed Item Care

For your clickers, grips, holders, coasters, and other 3D printed favorites. Follow any item-specific instructions included with your order.

Clean gently

  • Wipe with a soft, slightly damp cloth and dry thoroughly. For stubborn marks, use a little mild soap on the cloth and wipe away the residue.
  • Avoid soaking, abrasive scrubbers, and harsh solvents. Keep water away from clicker switches, hardware, and adhesive areas.
  • Hand-clean only. Do not put 3D printed items in the dishwasher, microwave, or oven.

Keep away from heat

Heat can soften or warp 3D printed pieces. Avoid hot vehicles, prolonged direct sunlight, heaters, and hot surfaces. Unless your item is specifically sold for hot use, keep it away from hot beverages and hot cookware.

Handle with care

  • Avoid drops, hard impacts, bending, and forcing parts together or apart.
  • For clickers, press the buttons gently and keep crumbs, sand, and other debris out of the mechanism. Do not pry off the buttons.
  • For phone and tablet grips, follow the attachment instructions included with your order. Check that the grip is secure before use, and avoid lifting a device by the grip alone.
  • For holders and coasters, wipe away spills promptly and allow the item to dry before storing it.

A note about the finish

Fine layer lines and small texture variations are normal features of 3D printing and make each piece a little unique.

Need a hand?

Reply to your order confirmation with your order number and a photo of the issue, or message the shop where you purchased your item.

Get hooked on our badge reels.

Made with care. Enjoy with personality!